71 – 80 of 279
- show: 10
- |
- sort: year (new to old)
Close
Embed this list
<iframe src=" "
width=" "
height=" "
allowtransparency="true"
frameborder="0">
</iframe>
- 2018
-
Mark
Selecting Cutting Data Tests for Cutting Data Modeling Using the Colding Tool Life Model
(
- Chapter in Book/Report/Conference proceeding › Paper in conference proceeding
-
Mark
Investigation of the mechanical properties and cutting performance of cBN-based cutting tools with Cr3C2 binder phase.
(
- Chapter in Book/Report/Conference proceeding › Paper in conference proceeding
-
Mark
Machinability and manufacturing cost in low-lead brass
(
- Contribution to journal › Article
-
Mark
Influence of graphite nanoadditives to vegetable-based oil on machining performance when MQCL assisted hard turning
(
- Chapter in Book/Report/Conference proceeding › Paper in conference proceeding
-
Mark
Tool Wear Mechanisms of pcBN tooling during High-Speed Machining of Gray Cast Iron
(
- Chapter in Book/Report/Conference proceeding › Paper in conference proceeding
-
Mark
CPR a general Cost Performance Ratio in Manufacturing - A KPI for judgement of different technologies and development scenarios
(
- Chapter in Book/Report/Conference proceeding › Paper in conference proceeding
- 2017
-
Mark
Modeling subsurface deformation induced by machining of Inconel 718
(
- Contribution to journal › Article
-
Mark
The influence of tool micro-geometry on stress distribution in turning operations of AISI 4140 by FE analysis
(
- Contribution to journal › Article
-
Mark
Quantitative study of roughness effect in nanoindentation on AISI316L based on simulation and experiment
2017) In Proceedings of the Institution of Mechanical Engineers. Part C: Journal of Mechanical Engineering Science 231(21). p.4067-4075(
- Contribution to journal › Article
-
Mark
Effect of cutting edge radius on surface roughness and tool wear in hard turning of AISI 52100 steel
(
- Contribution to journal › Article