1 – 20 of 30
- show: 20
- |
- sort: year (new to old)
Close
Embed this list
<iframe src=" "
width=" "
height=" "
allowtransparency="true"
frameborder="0">
</iframe>
- 2023
-
Mark
Structural changes in Ti1-xAlxN coatings during turning : A XANES and EXAFS study of worn tools
(
- Contribution to journal › Article
- 2021
-
Mark
Characterisation of worn WC tool using STEM-EDS aided by principal component analysis
(
- Contribution to journal › Article
-
Mark
Numerical investigation on the formation mechanism of residual stress in metal cutting
2021)(
- Thesis › Doctoral thesis (compilation)
-
Mark
Evaluation of tool wear mechanisms and tool performance in machining single-phase tungsten
(
- Contribution to journal › Article
- 2020
-
Mark
Investigation of mechanical and thermal loads in pcBN tooling during machining of Inconel 718
(
- Contribution to journal › Article
-
Mark
Machinability evaluation of low-lead brass alloys
2020) 29th International Conference on Flexible Automation and Intelligent Manufacturing, FAIM 2019 In Procedia Manufacturing 38. p.1723-1730(
- Contribution to journal › Article
-
Mark
There is logic in logit - Including wear rate in Colding's tool wear model
2020) 29th International Conference on Flexible Automation and Intelligent Manufacturing, FAIM 2019 In Procedia Manufacturing 38. p.1066-1073(
- Contribution to journal › Article
- 2019
-
Mark
Tool Life and Cutting Data Modelling in Metal Cutting : Testing, Modelling and Cost Performance
2019)(
- Thesis › Doctoral thesis (compilation)
-
Mark
Tool wear by dissolution during machining of alloy 718 and Waspaloy : a comparative study using diffusion couples
2019) In International Journal of Advanced Manufacturing Technology(
- Contribution to journal › Article
-
Mark
Multi-objective testing of different brass alloy components for DFM
(
- Chapter in Book/Report/Conference proceeding › Paper in conference proceeding
- 2018
-
Mark
Development of a simulation model to study tool loads in pcBN when machining AISI 316L
(
- Contribution to journal › Article
- 2017
-
Mark
An integrated cost model for metal cutting operations based on engagement time and a cost breakdown approach
(
- Contribution to journal › Article
-
Mark
Too Sharp for its Own Good – Tool Edge Deformation Mechanisms in the Initial Stages of Metal Cutting
(
- Contribution to journal › Article
- 2015
-
Mark
Numerical Modelling and Analysis of Orthogonal Metal Cutting
2015)(
- Thesis › Doctoral thesis (compilation)
- 2014
-
Mark
Machinability of Ductile Single-Phase Materials Used in Accelerator Components - A Study with Focus on Surface Integrity
2014) Swedish Production Symposium, 2014(
- Chapter in Book/Report/Conference proceeding › Paper in conference proceeding
- 2013
-
Mark
Influence of the tool surface micro topography on the tribological characteristics in metal cutting – Part I Experimental observations of contact conditions
(
- Contribution to journal › Article
- 2012
-
Mark
Analytical Calculation of the True Equivalent Chip Thickness for Cutting Tools and its Influence on the Calculated Tool Life
(
- Contribution to journal › Article
-
Mark
Methodology for evaluating effects of material characteristics on machinability-theory and statistics-based modelling applied on Alloy 718
(
- Contribution to journal › Article
- 2011
-
Mark
A numerical and experimental investigation of the deformation zones and the corresponding cutting forces in orthogonal cutting
(
- Chapter in Book/Report/Conference proceeding › Paper in conference proceeding
-
Mark
Machinability of duplex stainless steels - A study with focus on the tool wear behaviour
(
- Chapter in Book/Report/Conference proceeding › Paper in conference proceeding